收藏本站
CAT28F001
READ OPERATIONS
Read Mode
The CAT28F001 memory can be read from any of its
Blocks (Boot Block, Main Block or Parameter Block),
Status Register and Signature Information by sending
the Read Command Mode to the Command Register.
CAT28F001 automatically resets to Read Array mode
upon initial device power up or after exit from deep
power down. A Read operation is performed with both
CE and OE low and with RP and OE high. Vpp can be
either high or low. The data retrieved from the I/O pins
reflects the contents of the memory location correspond-
ing to the state of the 17 address pins. The respective
timing waveforms for the read operation are shown in
Figure 3. Refer to the AC Read characteristics for
specific timing parameters.
Signature Mode
The signature mode allows the user to identify the IC
manufacturer and the type of the device while the device
resides in the target system. This mode can be activated
in either of two ways; through the conventional method
of applying a high voltage (12V) to address pin A9 or by
sending an instruction to the command register (see
Write Operations).
The conventional method is entered as a regular read
mode by driving the CE and OE low (with WE high), and
Figure 3. A.C. Timing for Read Operation
applying the required high voltage on address pin A9
while the other address line are held at VIL.
A Read cycle from address 0000H retrieves the binary
code for the IC manufacturer on outputs I/O 7 to I/O 0 :
Catalyst Code = 0011 0001 (31H)
A Read cycle from address 0001H retrieves the binary
code for the device on outputs I/O 7 to I/O 0 :
CAT28F001T = 1001 0100 (94H)
CAT28F001B = 1001 0101 (95H)
Standby Mode
With CE at a logic-high level, the CAT28F001 is placed
in a standby mode where most of the device circuitry is
disabled, thereby substantially reducing power con-
sumption. The outputs are placed in a high-impendance
state independent of the OE status.
Deep Power-Down
When RP is at logic-low level, the CAT28F001 is placed
in a Deep Power-Down mode where all the device
circuitry are disabled, thereby reducing the power con-
sumption to 0.25 μ W.
POWER UP
STANDBY
DEVICE AND
OUPUTS
DATA VALID
STANDBY
POWER DOWN
ADDRESS SELECTION
ENABLED
ADDRESSES
ADDRESS STABLE
tAVAV (tRC)
CE (E)
tEHQZ
OE (G)
tGHQZ (tDF)
WE (W)
tGLQV (tOE)
tELQV (tCE)
DATA (I/O)
RP (P)
HIGH-Z
tGLQX (tOLZ)
tELQX (tLZ)
tAVQV (tACC)
tPHQV (tPWH)
OUTPUT VALID
tOH
HIGH-Z
Doc. No. MD-1078, Rev. K
8
? 2008 SCILLC. All rights reserved.
Characteristics subject to change without notice
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
CAT28F020G-90T IC FLASH 2MBIT 90NS 32PLCC
CAT28F512L90 IC FLASH MEM 512KB 90NS 32PDIP
CAT28LV256GI-25T IC EEPROM 256KBIT 250NS 32PLCC
CAT28LV64WI-25T IC EEPROM 64KBIT 250NS 28SOIC
CAT28LV65WI25 IC EEPROM 64KBIT 250NS 28SOIC
CAT310W-T1 IC LED DVR 10CH AUTO 20SOIC
CAT32TDI-T3 IC LED DRVR WHITE BCKLGT TSOT-6
CAT3604VHV4-GT2 IC LED DVR WHT CLR BACKLT 16TQFN
相关代理商/技术参数
CAT28F001LI-90B 功能描述:闪存 (128x8) 1M 90ns RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel
CAT28F001LI-90T 功能描述:闪存 (128x8) 1M 90ns RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel
CAT28F001N-12B 功能描述:闪存 (128x8) 1M RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel
CAT28F001N-12BT 制造商:ON Semiconductor 功能描述:
CAT28F001N-12T 功能描述:闪存 (128x8) 1M RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel
CAT28F001N-12TT 制造商:ON Semiconductor 功能描述:
CAT28F001N-90B 功能描述:闪存 (128x8) 1M RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel
CAT28F001N-90T 功能描述:闪存 (128x8) 1M RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel